![]() I found I could use 70 gr bullets that were for the 32 ACP.ħ. ![]() Full length size the case again and prime.Ħ. either way you want to end up with a reasonably thick neck that you can seat a. If you decap in a separate operation without an expander then you will need a. This assumes that your expander expanded the neck to. It will look just like a 7.62X25 case but the brass will be really thick at the neck.ģ. Lube the case and run it into your 7.62X25 sizing die to full length size and decap the case. ![]() You can use any bad brass as long as the primer pocket is good and the head of the case is intact.Ģ. With a small tubing cutter cut the brass at the mark. It does not have to be too accurate at this point, you will trim to length later, just don't make it too short. I used a sliding bevel carpenters square for this. Take a 223 case and mark it at about 1 1/16" roughly from the base. It makes what was the cheapest brass at the time into some of the most precious brass that you will ever see, if you count your time as being worth anything.ġ. Here is step by step instructions that will work. When I got my tokarev pistol about 20 years ago the only ammo readily available was Chinese steel case FMJ loads, which worked alright but I wanted to be able to shoot it even if the powers that be (The Clintons) cut off the ammo supply.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |